Mosaic, because of its strong anti-slip, wear-resistant, water resistance, plasticity and other functions, has become the first choice for many people to decorate bathrooms. If they are well matched, they are very modern, and the white bathroom equipment can produce a high-look Value bathroom?
● Shower room
The bathroom may be the most suitable place for the whole family to apply mosaic elements, beautiful and non-slip. Large area paving mosaic tiles can better reflect the owner's financial resources and taste than any other bathroom tile.
● Shower niches and floors
● Back wall of bathroom mirror
▲ Whether it is covered with the entire wall, only half of it, or even only one, it will have a good effect.
Mosaic Tile Tips
Brush glue
Glue brushing is the key to paving the mosaic. Prepare strong tile glue that is mixed in proportion. Apply the tile glue to the wall with a trowel. Pay attention not to apply too much. First apply the glue on the wall surface, and then use a smooth trowel to apply the glue evenly. Generally, the thickness of the glue is about 20mm. Note that the stirred mosaic adhesive glue should be used up within 2-3 hours according to weather conditions.
Brick Glass Mosaic
2. Tile
After brushing the glue, lay the mosaic according to the drawing's alignment gap, and use a trowel or putty shovel to hold the mosaic tightly, or pad it on the surface of the mosaic with a flat thick wooden board and hit it evenly with a rubber hammer to ensure a firm paste. Because each small piece of mosaic is fixed with a mesh, after it is attached to the wall, the glue penetrates into each small grid to achieve a fixed effect.
3. Check the condition of laying
After paving a certain range of mosaics, check the paving. First of all, the gap between bricks must be determined to be a uniform width. In this way, a small gray shovel is used to adjust the gray seam. This is the process that requires the most patience during the mosaic process, but the process Is the most important link. In addition, check for defects in the paved mosaic, and fill in the falling small mosaic.
4.Seam
After the inspection is completed, after the moisture is properly dried and has the initial strength, the jointing should be started. Prepare the required joint filler. Fill the joint into the mosaic gap with a trowel. Pay attention that the area of each scraper does not exceed 2 square meters. The jointing agent is evenly applied to the mosaic surface, ensuring that all gray joints can be completely filled and there is no excess residue. When sewing, please pay attention to wipe the sealant on the surface of the mosaic with a damp cloth within 20-25 minutes after filling.
We are brick glass mosaic manufacturer. We provide high quality brick glass mosaic. If you have any needs for our products, please feel free to contact us.
